Knowledge Base | WAN

-  Server Load Balancing
-  Load Balancing and Failover based on WAN quality
-  Change the VLAN ID range reserved by Vigor Router itself
-  Use preferred DNS server on Vigor Router
-  PPPoE Overview and Troubleshooting ways
-  Set up WAN priority on VigorLTE 200n and Vigor2620 LTE series router
-  What is NAT loopback?
-  What to do if the NAT/ VPN Performance is lower than expected?
-  Adding LTE Connection to a Broadband Router using VigorLTE 200 or Vigor2620L in LTE Bridge Mode
-  The different LTE status and the meanings on Vigor LTE Router
-  Bridge two Vigor3900/2960's LAN over GRE Tunnel
-  What is Fast NAT and when to use it? (For Vigor3900/2960)
-  Customer Tag and Service Tag
-  Activate a backup WAN during times of heavy load
-  Aggregate WAN's Bandwidth
-  Capture full Syslog about the USB Modem
-  Specify the MAC Address of WAN Interface
-  Troubleshoot for no Internet connection or website not loading completely
-  Set Up Multi-PVC and Open a Virtual WAN Interface
-  Set Up Multi-PVC and Bridge to a LAN Port
-  Capture Packets on Router's WAN
-  Load Balancing and Failover for multi-WAN Vigor Routers
-  Set up more WANs for Vigor3900
-  Set up dual USB WAN and do load balancing on Vigor3900/2960
-  'Auto Weight' and 'According to Line Speed' in Load Balance
-  WAN Inbound Load Balancing by Vigor3900
-  WAN Inbound Load Balance in Failover mode by Vigor3900
-  Use the same VLAN ID on different WANs (For Vigor3900/2960)
-  Built-in 4G/LTE WAN Setup
-  Which 3G/4G/LTE modems are compatible with Vigor Routers?
-  Add IPv6 address on router's WAN interface
-  Use Client Key for DynDNS Service
-  Optimize the MTU Size
-  Introduction to Hardware Acceleration
-  3G/4G/LTE WAN Setup
-  Difference between WAN Connection Detection modes
-  Add Wireless Internet Connectivity by Wireless WAN
-  Troubleshoot the Router's 3G/4G/LTE Connection
-  Track WAN Data Usage by WAN Budget