Vigor DSL Routers support adjusting ADSL/ VDSL SNR value by typing the command "adsl snr" or "vdsl snr" in router's command-line interface. With this command, we may reduce SNR value to improve the DSL sync speed, or to increase SNR value to improve the ADSL/VDSL stability. Below shows how to use the "adsl snr" command.
2. Enter command
adsl status to check the current SNR value. The below example shows the current SNR Margin is 8 dB.
3. Enter command
adsl snr ? to check how to use it.
adsl snr 50for the router to try synchronizing with an SNR value 5dB higher
4. After ADSL restarts, enter command
adsl status to check the new SNR value. We can see the current SNR Margin increased to 11 dB.
NOTE: The new SNR value will not be exactly the value of 8 dB plus 5 dB. It is because the actual synchronization result depends on the negotiation with DSL IPDSLAM; however, Vigor Router will try to get synchronization with a higher SNR value.
If the SNR value or the DSL stability is not as good as you expected, please try other DSL modem codes to improve
Was this helpful?
Thank you for your feedback :)
Sorry about that. Contact Support if you need further assistance, or leave us some comments below to help us improve.